|
|
MAIN FEATURES
- Rigid & robust steel construction
- Structural strength to 70 tonnes
- Axle weighing capacity 30 tonnes
- Maximum weighing to 60 tonnes without failure or loss of calibration
- Static or Dynamic Axle Weighing
- Platform Size: 900mm x 3000mm
- 4 Nos. OIML R60 C3 Load Cells
- Low cost & easy maintenance
|
|
|
|
|
SYSTEM DESCRIPTION
The WB30L axle weighbeam is designed to interface with the LO-TRAC® 100 and 200 axle weighing systems. The weighing platform sits in a steel pit frame which is permanently installed into a flat and level concrete apron (weigh lane). It is supported in each corner by four folded ‘S’ tensile load cells mounted within specially designed shoes. |
|
|
Axle weighing is suitable for check weighing commercial vehicles prior to leaving the loading area or by Government authorities for axle and gross vehicle weight enforcement.The WB30L is nominally rated at 30 tonnes however maximum capacity is to 60 tonnes which is sufficient to safely weigh grossly overloaded or abnormally loaded vehicles.
Note: The axle weight of normally loaded vehicles is 10-12 tonnes but even excessive single axle loads do not exceed 18 tonnes.
Downloads: Data Sheet PDF (400KB) |
|
| LO-TRAC® is a registered trade mark of TDC Systems Ltd |
|
